Carved Wave Door Media Console with Rounded Ends

Turn the room down and this is what you are left looking at. Long carved waves travel across four doors and keep going into the rounded end panels, so the piece has no hard corners to stop the eye. Slim vertical pulls sit where the crests break. The top is one clean plane, wide enough for an amp, a turntable or whatever your setup needs.

The waves are cut into panels built from joined blocks of solid wood, then sanded through the curves until they feel continuous under a palm. The finish sits close to the timber rather than over it, so the figure in the grain and the carved lines move together instead of competing. Each console is made after your order comes in.

It ships to you disassembled. That keeps the carved faces and the curved ends safe on the road, and it keeps the shipping bill honest. Case panels, doors and turned legs come with matched hardware and step by step drawings. Assembly is straightforward, and if you would rather have a hand, write to us and we will help.